Problem Guiding with QHY6

[NAG]

Hello,

I’m sorry about my English

I have one QHY6 about a year ago, and never have any problems.  I use it only for guiding, via ST4, with Maxim Driver and the EQ6 mount.

About two weeks ago, I’m starting having problems.  The calibration routine always fails, just because the mount doesn’t move.   I cannot guide via ST4 on PHD either .

I try successfully guiding via EQMOD (PulseGuide).

I already change the guide cable (pin-to-pin), but the problem remains.  Can someone help ?

Perhaps it’s a Driver problem. Which driver must use for guide via ST4?  I have the ASCOM 5.5 installed.

Thanks

Nuno Gameiro

[mega1977]

Same problem here,
calibration fails cause of no movement north (i've verified south correction are executed)
it seems camera port failure (cable is fine), but could be the mount.
By ascom works fine

[CZB]

Hello,
   Please creat a repair ticket:http://qhyccd.com/en/top/contact/ 
   I think your QHY6 camea should send back for a repaired,and if you have oscilloscope and soldering iron,perhaps I can tell you the test manual.


Best Regards

[mega1977]

hello
i could have possibility to test it by oscilloscope.
Please give me instructions if you can