QHYCFW3 Problem

[NAG]

Hello, i just bought one QHYCFW3 Filter Wheel. I installed both drivers as said in this page:
https://www.qhyccd.com/index.php?m=content&c=index&a=show&catid=137&id=34&cut=2

The driver conects without any problem, but i have these strange behavior as shown in attacht

What am i doing wrong ?

Thans verry much

[Yuki]

Hi，

It is the software issue.

This is how the third-party software is defined, we have no way to change.

If you connect EZCAP_QT , it will display the correct number of filter wheel holes.

Best Regards

[NAG]

Hi,

I'm sorry but i don't think that the problem it's on the N.I.N.A's side at all. I've used some filter wheel ASCOM drivers, i've write a couple of them myself, and i've never seen this behavior.

A think that i can't use EZCAP with ASCOM drivers, so i cannot test with it.

Is the ASCOM drivers source code avaliable somewere ?

Thank you very much

[lll]

Hi，
 
Using the connection mode of USB to Serial Port Convertor, the latest  ASCOM (USB) driver version 2.0.5 (which has not been uploaded to the official website) can correctly display the number of hole positions.
Link address:
https://www.qhyccd.com/file/repository/latestSoftAndDirver/Soft/QHYFW[RS232]ASCOM_V0.2.0.5_Setup.zip

 Note: There is no way we can change the number of links displayed through ASCOM(4PIN).
Best Regards

[NAG]

It's working

Thank you very much